Skip to content

How to Manually Configure failSAFE IP Interfaces

Last modified:

The failSAFE IP product provides network redundancy by allowing the same IP address to be configured on multiple interfaces.

This guide demonstrates how to manually configure failSAFE IP on a single OpenVMS node using two Ethernet interfaces.

In this example:

  • WE0 uses the primary IP address 10.1.1.1.
  • WE1 uses the primary IP address 10.1.1.2.

Each interface is also configured as the standby interface for the other. Only one instance of an IP address is active at a time. The failSAFE service continuously monitors interface status and automatically performs failover and recovery operations when necessary.

Get started