Configure the Standby Interfaces¶
Configure additional failSAFE standby interfaces so that each interface can assume ownership of the other interface's IP address during a failure.
$ TCPIP SET INTERFACE WEA0 /HOST=10.1.1.2 -
_$/NETWORK_MASK=255.255.255.0 -
_$/BROADCAST_MASK=10.1.1.255
Save the permanent configuration:
$ TCPIP SET CONFIGURATION INTERFACE WEA0 /HOST=10.1.1.2 -
_$/NETWORK_MASK=255.255.255.0 -
_$/BROADCAST_MASK=10.1.1.255
$ TCPIP SET INTERFACE WEB0 /HOST=10.1.1.1 -
_$/NETWORK_MASK=255.255.255.0 -
_$/BROADCAST_MASK=10.1.1.255
Save the permanent configuration:
$ TCPIP SET CONFIGURATION INTERFACE WEB0 /HOST=10.1.1.1 -
_$/NETWORK_MASK=255.255.255.0 -
_$/BROADCAST_MASK=10.1.1.255